Has anyone had any luck using an Accedian NID to test a circuit with the far end being a benchmark reflector?
It has been a while but if I recall they do a mac swap in hardware much like a reflector setup in the Ciena line. It can be done based on vlan, mac address or port if I recall...
Should be same as using a benchmark/reflector. You have to make sure the test appliance is using the mac address of the reflector to send the test packets. If doing as a S-Vid or C-vid they id's have to match up.
Did you find a resolution to your question?
If so, I am also interested.
Retrieving data ...