i have ciena done 6500 installation and commisioning and upgradation how i to know each ports of working MLA OTR100G and SFP
Hi Viswanath, I've branched your question into a new thread in our 6500 forum. I'm sharing it with users of that forum and our Converged Packet Optical forum should others have best practices, tips and resources to share with you. I'll continue to monitor your question to make sure your receive a response.
Primary and Secondary states of Equipment and Facility provides the status.
E.g. IS indicates In-Service, OOS indicates Out of Service.
Please refer "Equipment and facility primary and secondary states" section in Technical document, "323-1851-102.1_(6500_R12.2_CommonEqpt)_Issue1" for description of all the available states.
Not sure if i got your question right but as mentioned by Sumit, the primary and secondary states of each equipment and facility will provide you with the status of those equipment and/or facility. Now if your question is on how to test if each port in your system is working properly as design, please refer to "Photonic layer site testing procedure" section in the Commissioning and Testing document (323-1851-221). The said section will also show you how the different modules are connected to each other, whether you have a line amplifier site or a ROADM site.
I hope this info will help you.
Hi Chanalu, did Sumit and Jojo's recommendations help? Please let us know if you were able to confirm the ports are working, or if you still need help and would like assistance. We look forward to hearing from you.
Retrieving data ...