I'd like to configure a 6x device to be an ENNI in an eAccess circuit.
What is the recommended configuration to achieve this assuming the requirement is for color-blind services?
Did you resolve your 3960 ENNI eAccess question?
I found this option in the config guides:
traffic-profiling ...... remark-both-rcos-only green-remark-rcos 3 yellow-remark-rcos 3
I haven't tested it yet, but I think that if this is applied to the enni port it will meet the criteria of making the service color blind.
I'll take a look at my configs running here, and will post here. Hopefully later today,
Here's what I found:
PCP and/or DEI will be handled by IPAG2
ENNI NTE will pass those values (PCP and DEI) “transparently”
ENNI UNI and NNI port ingress will keep the modified DefaultFcosRcos table,
and egress policy will keep the default frame cos policy – i.e. ignore
traffic-services cos-mapping resolved-cos-map
set cos-map DefaultFcosRcos dot1dpri-cos 6-7 dot1dpri-dei 0 r-cos 0 r-color green
I was originally using traffic-services as you recommended above. This created a challenge.
traffic-services are applied to a port, so all services on that port would have that traffic-service applied.
In the case of an ENNI port, there would be multiple services with different Class of Service requirements. Using the following requirement:
ENNI port with (3) services (assuming vlans, but vlan xc could also be used).
Each service must be color-blind (can accept any dot1dpri).
Service 1 must leave the INNI port with a rewritten outer dot1dpri to 0 (best effort)
Service 2 must leave the INNI port with a rewritten outer dot1dpri to 1 (Bronze)
Service 3 must leave the INNI port with a rewritten outer dot1dpri to 3 (Gold)
I haven't tried using `vlan xc` but using normal vlan config, the `traffic-services` config does not appear to allow a way to handle the above scenario because the `traffic-services` map is applied to the entire ENNI (or INNI) port.
Retrieving data ...